32
7-3. MINIMUM DELAY
Minimum Delay mode allows users to perform signal processing from input to output in a
minimum amount of time, within 4
μsec. (See section 6-5-4.) In normal processing mode,
processing takes about 1 H and can control all menu parameters.
In minimum delay mode, AES or analog audio can be embedded to the SDI output stream, but
the SDI input audio channels cannot be remapped.
RELAY PASS THROUGH
PLL
SYNCGEN
SDI IN
SDI
Detection
TV system
-
Detection
1H DLY
+
SDI OUT
AES IN
ANALOG IN
(OPTION)
EMB
Input
process
AES
Input
process
ANALOG
Input
process
1kHz
TEST SG
MAPPING
EMB
Output
process
Available Menu Parameters in Minimum Delay mode
Section
Menu Parameters
AES IN SYNC MODE
AES IN PCM MODE
ANALOG INPUT LEVEL
AES IN GAIN and ANALOG GAIN
SDI OUT MAPPING
Available settings:
AES CH1 to 8
and
ANA CH1 to 8
SDI OUT STEREO MODE (Available only for channels to which AES or
analog input audio is assigned.)
SDI OUT RESOLUTION (Available only for channels to which AES or
analog input audio is assigned.)
SDI OUT GAIN (Available only for channels to which AES or analog input
audio is assigned.)
LTC MUX
LTC SEL
6-5-1 to 7
All System menu parameters
6-6-1 to 12
All Status menu parameters
Processing in Min.
delay mode
USO
RESTRITO