9
●
●
●
●
Installation
3. Installing the awning
Lift the awning and insert the supporting bar (4) into the wall brackets (1).
Make sure that the middle bracket is located at the centre of the supporting bar of the awning frame.
4. Securing the supporting bar
Secure the supporting bar (4) on the wall brackets (1) by inserting the three fastening bolts (F) up
through the holes on each wall bracket.
Place the washer and M10 nut on each fastening bolt. Tighten the nuts with a wrench to secure the
bolts.
CAUTION!
When placing the awning on the wall, the crank loop should be facing downward,
perpendicular to the ground. The awning arms can swing out while installing if held
incorrectly.
Note:
If the supporting bar cannot be easily fitted to the wall brackets, slightly lift the front side of
the awning.
1
4
1
1
F
1
4
