12
10
Remove clamp bars after top beam is secured
Failure to remove clamp bars may result in incomplete melt zone at ends of splices
that are full press width.
11
Connect umbilical power cable from top beam to bottom beam
(Fig. 10)
a. insert umbilical power cable connector into machine base umbilical cable connector.
b. engage latch to lock plug in place. Forgetting to latch plug can result in intermittent
power supply to press base controls.
12
Connect power cord to press
(Fig. 11)
Warning
it is extremely important that the power cord is attached to the press first and then to
the wall receptacle. reversing these procedures can put personnel at risk of electrocu-
tion and may cause a damaging electrical arc.
a. insert power cable connector to the machine base power outlet.
b. engage latch to lock plug in place. Forgetting to lock plug can result in intermittent
power supply to the press.
Danger
c. double check to ensure the voltage and receptacle is appropriate for the power
cable you are using. incorrect, excessive power voltage can cause serious damage to
press and also present physical danger (i.e. 460 volt outlet feeding into a 230 volt
cable could cause a short circuit and/or fire).
d. next, insert power cable plug into the appropriate wall receptacle. (Fig. 12)
Important
only plug power cord into wall receptacle after power cord has been attached to the
tool.
Danger
e. user wiring of electrical plug to bare power cable end or hard wiring cable to junc-
tion box must be in accordance with the ‘Wiring diagram of power supply cable’
on page 20. ensure proper cable diagram is used for cable being wired. ensure the
correct plug is used. only qualified personnel should perform this activity.
the heating press has 3 controllers:
1. the temperature controllers are located on the top beam.
a. programming:
splice temperature (max 200 °C/392 °F), splice dwell time, cool down temperature.
2. the pressure controller is located on the bottom beam and controls the pressure up
to 2.5 bars/36.3 psi.
Fig. 10
Fig. 11
Fig. 12
saFe operation
Latch
Latch
Latch
Summary of Contents for siegling blizzard HP 160/1000 AIR
