Introduction
Setting Up the Module Unit
ModuSys 2000 Kernel
1-17
3
1
2
Setting Up the Module Unit
This section describes how to set up the module unit. It contains
information on:
•
Rear Panel Ports, Connectors, Controls and Indicators
•
Option Support
•
Choosing a Location for the Module Unit
•
Turning On the Module Unit
•
Turning Off the Module Unit
Front and Rear Panel Ports, Connectors and Controls
Table 10 lists the ports, connectors and controls on the front and rear panels
of the ModuSys 2000 kernel and describes their functions. The item
numbers in the first column of Table 10 refer to the various functions shown
in Figure 2 and Figure 3.
Figure 2: Location of the Front Panel Ports, Connectors, Controls and Indicators
Summary of Contents for MODUSYS 2000 Kernel
