Introduction
Setting Up the Module Unit
ModuSys 2000 Kernel
1-23
Turning On the Module Unit
Danger
Before connecting a power source, ensure that the voltage supply is
within the ranges specified in Table 3. Failure to observe these
precautions will result in damage to the module unit and may result in
injury.
Gefahr
Stellen Sie vor dem Anschluß an eine Spannungsquelle sicher, daß sich
die Versorgungsspannung innerhalb des in Table 3 genannten Rahmens
bewegt. Nichtbeachtung dieser Vorsichtsmaßnahmen führt zu
Beschädigung der Moduleinheit und kann Verletzungen verursachen.
Turn on the module unit as follows:
1. Consult the user manuals for all peripherals that are connected to
the module unit to ensure that you follow the appropriate power
sequencing procedure for each peripheral.
2. Set the power switch on the rear of the module unit to ON.
3. When the power is ON, the power-on indicator labeled PWR is
illuminated.
5. See the user information manual for the specific SBC in each
module unit for more information on the SBC power-up tests
6. Boot the operating system. See the operating system
documentation for further information on the correct boot
procedure to use
Turning Off the Module Unit
Turn off the module unit as follows:
1. Shut down the operating system, following the instructions in the
operating system user information.
2. Set the power switches on all peripherals that are connected to the
module unit to the OFF position.
3. Set the power switch on the rear of the module unit to OFF.
Summary of Contents for MODUSYS 2000 Kernel
