Dismounting a Module Unit from the Rack Frame
Accessing Internal Components
3-6
ModuSys 2000 Kernel
Dismounting a Module Unit from the Rack
Frame
Danger
When accessing the module unit mounted on a rack, take precautions to
ensure that the rack does not overbalance.
Gefahr
Beim Umgang mit einer auf einem Gestell montierten Moduleinheit ist
darauf zu achten, daß das Gestell nicht kippt.
To dismount the module unit, carry out the following steps:
1. Remove all cables from the rear of the module unit.
2. Ensure that all other equipment installed in the rack is fully
pushed back.
3. Unlock the locking features that hold the module unit to the rack
frame.
4. If slides are fitted, slide the module unit forward on the chassis
slides, until the slides lock.
5. Release the chassis slides by pressing the slide locks on each side
of the module unit.
6. Using a lift, pull the module unit free of the rack rails.
7. Place the module unit on a level, stable surface.
Summary of Contents for MODUSYS 2000 Kernel
