Installing and Removing Option Boards
Removing an SBC
ModuSys 2000 Kernel
5-13
Removing an SBC
Danger
Make sure that the mains power supply is disconnected from the module
unit before continuing.
Gefahr
Bitte trennen Sie die Moduleinheit von der Spannungsversorgung, bevor
Sie fortfahren.
Remove an SBC as follows (see Figure 28):
1. Follow the instructions in Chapter 3 to dismount the module unit
from a rack if additional access is required.
2. Note the location and orientation of all cables connected to the
SBC (1).
3. Disconnect any cables attached to the SBC. You may wish to
remove some cables after removing the SBC from the backplane.
4. Disengage the two retaining locks (2) that secure the SBC to the
chassis.
5. Carefully remove the SBC from the SBC connector on the
backplane.
Caution
!
Take care when handling the SBC. The active components on the SBC
are sensitive to electrostatic discharge (ESD), and can easily be damaged.
Take anti-ESD precautions such as wearing isolation gloves or an
antistatic wriststrap.
Vorsicht
!
Vorsicht im Umgang mit der SBC-Platte. Die aktiven Bauteile auf der
SBC-Platte dürfen keiner elektrostatischen Entladung (ESD) ausgesetzt
sein und können leicht beschädigt werden. Bitte treffen Sie
Vorkehrungen gegen ESD, wie beispielsweise durch Tragen von
Isolierhandschuhen oder antistatischem Armband.
Summary of Contents for MODUSYS 2000 Kernel
