EN
Center of Gravity (CG)
The CG location is measured from the leading edge of the wing at the root.
This CG location has been determined with the recommended Li-Po battery
installed all the way forward in the battery compartment.
89mm
back from lead-
ing edge at
the root.
Control Surface Centering
After assembly and transmitter setup, confi rm that the control surfaces are
centered. If the control surfaces are not centered, mechanically center the
control surfaces by adjusting the linkages.
If adjustment is required, turn the clevis on the linkage to change the length of
the linkage between the servo arm and the control horn.
After binding a transmitter to the aircraft receiver, set the trims and
sub-trims to 0, then adjust the clevises to center the control surfaces.
Clevis Installation and Control Centering
Clevis Installation
• Pull the tube from the clevis to the linkage.
• Carefully spread the clevis, then insert the clevis pin into the desired hole in
the control horn.
• Move the tube to hold the clevis on the control horn.
1.
2.
3.
4.
5.
6.
Bare Bear
8
