FORCE1 RC
8
TRANSMITTER BATTERY INSTALLATION
PHONE CLIP INSTALLATION
1. Pull up the phone clip (Fig. 3), open the lower clamp, then pull the upper clip until it can hold the
phone (Fig. 4).
2. Put the phone into the clip, then release the clamp, the clamp will hold the phone tightly (Fig. 5/6).
FIGURE 1
FIGURE 2
FIGURE 3
FIGURE 4
FIGURE 5
FIGURE 6
Open the battery cover and insert 4 AA batteries as shown below (not included).
• The transmitter needs 4 AA batteries to work
• Insert batteries in correct polarity (+) and (-)
• Don’t mix old and new batteries
• Don’t mix alkaline, standard (carbon-zinc) and rechargeable (nickel-cadmium) batteries
• Remove rechargeable batteries before charging
• Only charge batteries under adult supervision
• Remove spent batteries from the transmitter
• Regularly inspect the charging cable, cord, plug, enclose and other parts; if you notice damage, please
include your order number when you contact us at support@force1rc.com for fast, friendly service, or
visit Force1rc.com for a replacement
CAUTION:
Summary of Contents for U49W BLUE HERON
Page 2: ......
