U49W BLUE HERON
User Manual
27
Problem
Problem Cause
Solution
The transmitter
power indicator
light is off.
The drone cannot fly.
The drone power
indicator light is off.
The camera is not
working.
The drone and
transmitter are not
pairing with each
other.
The drone cannot
hover and/or tilts
to one side.
1. Low batteries.
1. The propeller is damaged.
1. Low battery.
1. The transmitter power indicator light is off.
1. Drone calibration was unsuccessful.
1. Replace all the transmitter batteries.
1. Replace the damaged propeller(s).
1. Charge the drone battery, then re-insert
battery into the drone.
1. Check the wire and connection to ensure
it’s fully plugged in.
1. Please see solutions under “The
transmitter power indicator light is off”.
1. Refer to Page 13 for calibration instruction.
3. Poor contact.
3. Incorrect installation of propellers.
3. Poor contact.
3. Damaged camera.
3. Proper steps not followed, missed step.
3. The motor casing/arm is damaged.
5. The motor is damaged.
2. The batteries’ positive poles and negative
poles are in reverse order.
2. Low battery.
2. The battery is expired or no longer
charging.
2. There is an interfering signal nearby.
1. The camera wire has no contact with the
camera box wire.
2. There is an interfering signal nearby.
2. A propeller is damaged.
2. Install the battery in accordance with
the User Manual instructions and check
polarity.
2. Charge the drone battery, plug the
charged battery into the drone, and
power on.
2. Buy a new battery from force1rc.com and
replace the battery.
2. Unplug the camera wire and reconnect.
2. Restart the drone and attempt to power
on and pair.
2. Replace the damaged propeller(s).
3. Clean the battery compartment with a dry
microfiber cloth to remove dust and dirt.
3. Check page 6 and 9 of the User Manual
for proper instructions.
3. Disconnect the battery, make sure it’s
clean and has no bent/broken prongs
then connect it to the drone again.
3. Buy a new camera box from force1rc.com.
3. Check page 14 and closely follow all steps.
3. Replace the damaged motor casing/arm.
5. Replace the motor (See page 9 for
instructions).
4. Buy spare parts from force1rc.com and
replace any damage parts.
4. Put the drone on flat ground for about 10
seconds or restart the drone to calibrate
again (page 13).
4. An electronic component is damaged
from frequent crashes.
4. The gyro did not reset after a crash.
Please include your order number when contacting us at support@force1rc.com
for fast, friendly service.
TROUBLESHOOTING
Summary of Contents for U49W BLUE HERON
Page 2: ......
