Force1 F200C SPECTER, User Manual

F200C Specter 

User Manual

11

DRONE ASSEMBLY CONT.

PROPELLER INSTALLATION/REMOVAL

PROPELLER A INSTALLATION
  Place  propeller  A  on  the  corresponding  motor  shaft  (Fig.  4).  The  side  marked  A  should  be  facing 

upwards. Fix the rotor propellers by rotating them as per the “lock direction shown on the propellers.” 
Place the rubber ring into the center bore of the propeller, then tighten the screws counterclockwise. 
Propeller A screws have a dot on top.

PROPELLER B INSTALLATION
  Place  propeller  B  on  the  corresponding  motor  shaft  (Fig.  4).  The  side  marked  B  should  be  facing 

upwards. Fix the rotor propellers by rotating them as per the “lock direction shown on the propellers.” 
Place the rubber ring into the center bore of the propeller, then tighten the screws clockwise. Propeller 
B screws do not contain a dot on the top.

REMOVAL
  Hold the brushless motor and unscrew the A screws clockwise and the B screws counterclockwise. Then 

rotate and remove the propellers as per the “unlock” direction shown on the propellers.

• Please be sure to install the correct propellers (matching A and B)
• Be careful with propellers, as they can be sharp 
• Purchase extra propellers at force1rc.com 

CAUTION:

SCREW WITH DOT

PROPELLER A REMOVAL

PROPELLER B REMOVAL

RUBBER RING

PROPELLER A (CLOCKWISE)

PROPELLER B (COUNTERCLOCKWISE)

CLOCKWISE ROTATING 

MOTOR IS MARKED 

WITH A WHITE DOT.

COUNTERCLOCKWISE 

ROTATING MOTOR IS MARKED 

WITH A BLACK DOT.

RUBBER RING

SCREW WITHOUT DOT

FRONT

REAR

A

B

A

A

B

B

B

A

FIGURE 4