Force1 F200W SHADOW, User Manual

F200W Shadow 

User Manual

13

CALIBRATION

TRANSMITTER CALIBRATION

1.  Turn on the transmitter.
2.  Push the Calibration button and hold for 3 seconds (Fig. 6). 
3.  Transmitter will beep 3 times, and the indicator light will start flashing slowely. 
4.  Rotate control sticks in any direction for 2 full rotations (Fig. 7).
5.  Push the Calibration button and hold again for 3 seconds. 
6.  Transmitter will beep 3 times, and the indicator light will start flashing faster indicating   

  calibration completion.

NOTE

Your transmitter is calibrated when manufactured, but may be required after a crash or notice of 
improper operation.

PAIRING WITH DRONE

When the transmitter is in signal connection status, power on the drone by inserting the battery. The 
transmitter will emit a single beep sound, and the signal icon        will appear on the LCD screen. This 
means that the drone has successfully linked to the transmitter. 

GYROSCOPE CALIBRATION

Set the drone on a horizontal surface. Push down both of the control sticks to the lower left corner (Fig. 
8). When the front and rear lights are both green and flashing rapidly, it means that the gyroscope is 
under calibration. When the lights turn solid, the calibration is successful. 

NOTE

•   All drone gyroscopes have been calibrated when manufactured  
•   Gyroscope calibration is required if pilots find the drone cannot exit the 

aircraft initialization detection procedure

•   Do not power on the drone when calibrating the transmitter

DRONE INITIATION

After signal connection, the drone enters Initialization Detection Mode, and 
the front and rear lights flash red, light green and green. Make sure the drone 
is on a flat, still surface for this; it takes about 8 seconds. Once the front and 
rear lights glow light green and flash, initialization detection is done and the 
drone enters compass calibration.

FIGURE 7

FIGURE 6

FIGURE 8