FORCE1
10
BATTERY REMOVAL
Make sure the drone power switch is in the “OFF” position. Open the battery cover using a
screwdriver and disconnect the wire of the battery from the receiver wire.
DRONE ASSEMBLY
PROPELLER GUARD INSTALLATION
Attach the propeller guard as shown in figure 5. Make sure that all three prongs are snapped into place.
Install a screw to the center prong to secure the guard completely.
BATTERY INSTALLATION
1. Open the battery cover using a screwdriver and insert the battery into the power port (Fig. 3).
2. Connect the wire of the 7.4v 350mAh lithium battery to the receiver wire in the power port (Fig. 4).
3. Replace the battery cover, and move the power switch to the “ON” position.
FIGURE 5
Install the battery firmly; failure to do so may affect flight safety.
CAUTION:
FIGURE 3
FIGURE 4
Summary of Contents for rogue F72
Page 2: ......
