11
Changing the Remote Control Transmitter Battery (Long-Range 1-Way
and 2-Way Remote Start System):
The (CR-2032 for 1-way transmitter and CR-2450 for 2-way transmitter) 3-volt lithium
battery supplied in your remote control should last approximately one year, depending
on usage. When the battery begins to weaken, you will notice a decrease in remote
transmitter operational range (the distance from your vehicle). Follow the instructions
below to change the remote transmitter battery.
1. Remove the small phillips screw (2-way transmitter only).
2. Gently pry apart the top and bottom halves of the transmitter case using a small
fl at tool.
3. Remove the old battery and replace with a new one. Be sure to observe the (+)
sign on the battery and case.
4. Carefully snap the case halves back together. Reinstall phillips screw (2-way
transmitter only), then test the remote control.
It is not necessary to re-program the remote control after changing the
battery, however the fi rst activation after changing the battery may require
several button presses to allow the transmitter to “re-sync” to the system.
Adding Remote Control Transmitters to Your System (Long-Range
1-Way and 2-Way Remote Start System):
The system has the ability to operate from up to 8 remote controls. Follow these
instructions to add a remote control to your system.
1. Open the driver’s door and enter the vehicle (shifter in park), leaving the driver’s
door open throughout the remainder of the process.
2. Press and hold the brake pedal.
3. Turn the vehicle ignition key from the OFF position to the ON position 6 times,
ending in the ON position (Off, On, Off, On, Off, On, Off, On, Off, On, Off, On).
Note, the brake pedal can be released after the fi rst Off to On cycle.
The horn will honk 3 times. This indicates that the unit has entered the remote
control programming mode.
4. Press & Hold** the button on the remote control to be programmed.
The horn will honk 1 time, indicating that the system has “learned” that remote
control.
5. Repeat step 4 for any additional remote controls.
6. Turn the vehicle ignition off to exit the programming mode. Test all remote controls
to ensure that they work properly.
Deleting Lost or Stolen Remote Control Transmitters from Your System
(Long-Range 1-Way and 2-Way Remote Start System):
Lost or stolen remote control transmitters can be easily deleted by reprogramming all
eight transmitter code locations. Follow the steps above and program any combination
of transmitters a total of eight times.
Remote Start System Maintenance
** “Press & Hold” or “Pressing and Holding” refers to pushing the transmitter button for more than
2.5 seconds.
4280760 Phase 2 VSS_RMST Owners Guide_P6.indd 11
4280760 Phase 2 VSS_RMST Owners Guide_P6.indd 11
4/27/2017 9:41:36 AM
4/27/2017 9:41:36 AM
