20. The vehicle doors will unlock-lock-unlock to confirm that your personal code has been
programmed to the keypad and the 9/0 button will flash twice to confirm that the keypad has
exited programming mode
C. Adhering the Keypad to the Vehicle
CAUTION: Do not adhere to moveable glass or windshield.
NOTE:
For proper adhesion, the mounting surface should be at least 60
°
F (15
°
C.)
The tape is very sticky and will adhere quickly once contact is made.
NOTE:
This product is designed to attach to your car door, centered between the door handle and the window
sill, but will work mounted to a relatively flat surface.
21.
Hold keypad up to desired mounting surface to confirm that all the tape will contact the mounting
surface.
22.
Clean the vehicle surface where the keypad is to be adhered with the alcohol wipe provided.
23.
Pull the tape tabs off the keypad tape, orient the keypad in the desired location and press onto the
door surface.
Be sure to press firmly on all edges to ensure proper adhesion of the tape.
D. Using the Keypad
NOTE:
Refer to the ‘‘Locks and Security’’ section of your vehicle Owner’s Guide for operation of
remote transmitters during RUN/START. Remote transmitter operation in RUN/START key position
is model dependent
.
24.
To unlock the driver’s door, enter your personal 5-digit code or the factory set code.
Each digit must be pressed within five seconds of each other.
25. To unlock all doors, press 3/4 button within five seconds of entering a valid keypad code.
26.
To unlock the trunk or hatch, if equipped, press the 5/6 button within five seconds of entering a
valid keypad code (IKT vehicles may require the 5/6 button to be pressed twice). Press the 5/6
button twice to open or close the passenger side power sliding door, if equipped.
27.
To unlock and open the driver side power sliding door, if equipped, press the 7/8 button twice
within five seconds of entering a valid code.
Page 3 of 4
SK7L2J - 19G544 – AA
© Ford 2007 FoMoCo
