INSTALLATION (Continued)
25.
NOTE:
A DVOM connected to the correct wire
29.
NOTE:
A DVOM connected to the correct wire
will show 12V, then show 0V when the horn
will show 0V, then show 12V when the door
button is held.
lock switch is pressed.
A logic probe will show open on the correct
A logic probe will show ground on the correct
wire, then show ground when the horn button is
wire, then show power when the door lock
held.
switch is pressed.
NOTE:
Wire is located inside wire convolute
Identify the Gray/Brown lock all motors circuit
running to connector C260 but does not
at the Smart Junction Box (SJB) connector
terminate. Wire can be found within 2-6’’ from
C2280D Pin 6.
connector on the side heading into main IP
30. Connect the White/Blue wire from the control
harness in a looped fashion underneath bright
module harness to the Gray/Brown lock all
green tape.
motors circuit wire at the SJB connector
Identify the Blue/White horn circuit wire under
C2280D Pin 6.
dash panel.
31.
NOTE:
Connect only if system will be used in
26. Connect the Brown/Black wire from the control
Lot Mode.
module harness to the Blue/White horn circuit
NOTE:
A DVOM connected to the correct wire
wire under dash panel.
will show 12V, then show 0V when the door
27.
NOTE:
A DVOM connected to the correct wire
lock switch is pressed.
will show 12V with the vehicle door(s) open
A logic probe will show open on the correct
and the dome light on, then show 0V with the
wire, then show ground when the door lock
vehicle door(s) closed and the dome light off.
switch is pressed.
NOTE:
A logic probe connected to the correct
NOTE:
Wire is located inside wire loom
wire will show power with the vehicle door(s)
running to connector C260 but does not
open and the dome light on, then show open
terminate. Wire can be found 4’’ from
with the vehicle door(s) closed and the dome
connector on the side heading toward the
light off.
bulkhead of the vehicle in a looped fashion
NOTE:
Wire is located inside wire loom
underneath bright green tape.
running to connector C260 but does not
Identify the Blue/Green power door lock circuit
terminate. Wire can be found 4’’ from
wire under dash panel.
connector on the side heading toward the
bulkhead of the vehicle in a looped fashion
32. Connect the Blue wire from the control module
underneath bright green tape.
harness to the Blue/Green wire under dash
panel.
NOTE:
Be sure that the dome light has timed
out and is off before performing the door closed
33.
NOTE:
Connect only if system will be used in
test.
Lot Mode.
Be sure that the dome lamp is illuminated
NOTE:
A DVOM connected to the correct wire
before performing the door open test.
will show 12V, then show 0V when the door
Identify the Gray/Violet dome light circuit wire
unlock switch is pressed.
under dash panel.
A logic probe will show open on the correct
wire, then show ground when the door unlock
28. Connect the Green/Violet wire from the control
switch is pressed.
module harness to the Gray/Violet dome light
circuit wire under dash panel.
Identify the Yellow/Violet door unlock circuit
wire at the SJB connector C2280C Pin 4.
2013 Mustang
Vehicle Security
4
Page 4 of 8
SK9L2J-19G364-AA
© Copyright Ford 2012 FoMoCo
