INSTALLATION (Continued)
69. Start the vehicle.
76. After the VSS system triggers the vehicle’s
horn and lights check that the LED has a fast
•
The vehicle should start normally without
flash sequence.
any VSS system trigger.
NOTE:
Only perform the following step if the kit
70. Turn off engine, exit the vehicle and close all
has the ’’optional‘‘ starter disable function.
doors.
77. Turn ignition key to the START position to
71. Arm the VSS system from outside of the car
verify ’’optional‘‘ starter disable function does
with the driver’s door window open. Verify the
not allow vehicle to start.
VSS system triggers when the following is
performed:
78. Press the OEM key fob unlock button to disarm
1 With security system armed, reach through
system.
open window and manually open the door.
•
Check that the LED has a fast flash
2 Verify VSS system triggers the horn honk
sequence.
sequence. Allow the VSS system to
complete the full 30 second alarm sequence.
79. With all doors closed and the driver’s window
down, re-arm the VSS system.
X
After the VSS system triggers the
vehicle’s horn and lights check that the
80. Reach through the driver’s side window and hit
LED has a fast flash sequence.
the steering wheel with moderate force in an
attempt to trigger the VSS system.
72. Disarm the VSS system by pressing the unlock
on the OEM key fob.
•
The horn and lights should go through the
30 second alarm sequence to indicate full
73. Re-arm the VSS system using the OEM key
trigger shock has been detected.
fob.
•
Check that the LED has a fast flash
sequence.
74. Reach through the driver’s window to press the
door unlock button trim switch.
•
Verify that the security system does not
disarm.
75. While sitting in the driver’s sear, start the
vehicle, with the VSS system armed and all
doors closed.
•
Let the horn and lights go through the 30
second alarm sequence.
2013 Mustang
Vehicle Security
8
Page 8 of 8
SK9L2J-19G364-AA
© Copyright Ford 2012 FoMoCo
