2013
Fiesta
- Key Start
Vehicle Security
1
GENERAL PROCEDURES
5.
Press and hold the VSS override button for at
least 10 seconds.
Programming
After 10 seconds the horn with honk 3 times,
indicating the system is now in the learn mode.
Programming the Module
6.
Press and release the override button. The horn
will honk 4 times indicating the system has
1.
NOTE:
Make sure that the hood and doors are
entered the first program bank.
closed before proceeding.
If not please check the following:
NOTE:
The LED on the VSS harness must be
visible to complete module programming.
•
All door and dome light circuit wire solder
connections.
NOTE:
The VSS override button must be
accessible.
•
The key is in the RUN position.
•
The software cartridge is firmly seated in
Programming Options: Entering
the VSS module.
Programming Mode
•
The VSS harness connections are firmly
seated in the VSS module.
2.
See chart below for programming information.
NOTE:
If you require additional assistance: CALL
Option Bank - 1 Chart (4 - Honks)
1-800-FORD KEY.
BANK
OPTIONS
DESCR
LED
7.
Press and release the Lock button on the trim
1
1
LITE
NOTE 1
TOUCH
switch
3
times.
ADJUST
The horn will honk
3
times indicating the
1
2
FULL
NOTE 1
system has entered the option
3
of the first
SHOCK
program bank.
ADJUST
1
3
DOOR
ON
NOTICE:
To turn the LED on or off, press and
AJAR
immediately release Unlock button on the trim
INVERT
switch.
1
4
UNLOCK
ON
SENSE
8.
The LED must be ON for option
3
. If the LED
INVERT
is illuminated no action is required. If the LED
is not illuminated press the Unlock button and
verify the LED illuminates.
Option Bank - 2 Chart (5 - Honks)
BANK
OPTIONS
DESCR
LED
NOTE:
When programming the VSS module, if the
2
1
STARTER
ON
Lock button is held for more than 3 seconds, the
INTERRUPT
horn will honk 4 times indicating the system
returned to the factory default settings. If this
occurs, return to step 1 of the programming section
NOTE:
Perform proper adjustments following the
‘‘Shock Sensor Setting’’
Procedures.
to reprogram the
VSS
module.
9.
Press and release the Lock button on the trim
switch.
3.
Open the driver door.
The horn will honk
4
times indication the
All other doors should remain closed.
system has entered the option
4
of the first
program bank.
4.
Turn the ignition key to the RUN position.
Page 1 of 2
SK9L2J-19G364-AA
© Copyright Ford 201
1
FoMoCo
