Identify Circuit Wires For Connections
NOTE:
Review vehicle specific wiring diagram(s) before proceeding.
NOTE:
Review proper wire splicing techniques before proceeding.
13. Connect the Black ground wire from the
VSS
module harness to the chassis ground point on
the drivers side.
• Chassis ground points are located near the drivers side sill plate.
14.
NOTE:
A DVOM connected to the correct wire will show 0V, then show 12V when the Ignition Switch is
in the RUN and START positions.
A logic probe will show ground on the correct wire, then show power when the Ignition Switch is in
the RUN and START positions.
Identify the Blue/Gray ignition circuit wire at BCM C2280B Pin 4.
15. Connect the Pink wire from the control module harness to the Blue/Gray ignition circuit wire at
BCM C2280B Pin 4.
16.
NOTE:
A DVOM connected to the correct wire will show 0V, then show 12V when the Ignition Switch is
in the START position.
A logic probe will show ground on the correct wire, then show power when the Ignition Switch is in
the START position.
Identify the White/Green starter circuit wire at the passengers kick panel.
17. Cut the White/Green starter circuit wire at the passengers kick panel.
INSTALLATION (Continued)
2013 Fiesta - Push Button Start
Vehicle Security
5
Page 5 of 9
SK9L3Z-19G361-AA
© Copyright Ford 2012 FoMoCo
