D - 12
ForeRunner
ATM Switch Network Configuration Manual
Configuring FramePlus Modules
D.5 Configuring Frame Relay
To configure Frame Relay on a FramePlus network module, these steps must be performed in
the following order:
1.
Choose or create any profiles that you wish to use.
2.
Create each service that you need and associate the profile(s) with it.
3.
Create each PVC and associate the profile(s) and service(s) with it.
These steps are described in detail in the following sections. There are also steps described for
configuring SPANS SPVCs and PNNI SPVCs on a FramePlus network module.
NOTE
A FramePlus network module can run either a
Frame Relay over ATM or Frame-based User to
Network Interface (FUNI) application. Because
Frame Relay is the default, it is assumed that you
do not need to change the application from FUNI
to Frame Relay at this point. If you need to
change the application, see the instructions in
Section D.6.1. The
Appln
field under
conf
mod
display
shows which application is currently
running (either
fratm
for Frame Relay or
funi
for FUNI).
D.5.1 Choosing Frame Relay Profiles
First, you need to decide which profiles you want to use. For most profile types, several
default profiles are provided for your convenience. If a service or connection is created without
specifying any profile, the first default profile in the list (index 0) is used.
To display the default profiles, use the show command under each profile; e.g.,
conf
profile
epdppd
show
. If these defaults do not match your network’s needs, you can create
your own using the
new
command under each profile; e.g.,
conf
profile
epdppd
new
. Cre-
ate the new profiles for each profile type that you are going to use. Once you have determined
which default profiles to use, you can move on to Section D.5.2.
Summary of Contents for forerunner series
