ForeRunner
ATM Switch Network Configuration Manual
D - 17
Configuring FramePlus Modules
Con
figurin
g
Fram
ePlus
M
odule
s
D.6 Configuring FUNI
To configure FUNI on a FramePlus network module, these steps must be performed in the fol-
lowing order:
1.
Change the application key, if necessary.
2.
Choose or create any profiles that you wish to use.
3.
Create each service that you need and associate the profile(s) with it.
4.
Create each PVC and associate the profile(s) and service(s) with it.
These steps are described in detail in the following sections. There are also steps described for
configuring PNNI SPVCs on a FramePlus network module.
D.6.1 Changing the Application Key
This command lets you configure a FramePlus network module to run either Frame Relay over
ATM or to run frame-based User to Network Interface (FUNI). The network module can only
run one application or the other at a time. However, you can have some network modules run-
ning FUNI and some running Frame Relay in the same switch fabric.
FramePlus network modules run Frame Relay by default. To run FUNI services on the network
module, please contact FORE’s Technical Assistance Center for a valid FUNI key. To change
from FUNI back to Frame Relay, the key is
fratm170358
. The
Appln
field under
conf
module
display
shows you which application is currently running.
myswitch::configuration module> display
Module Appln Appl Boot Stats Oam Operational Product
swRel swRel monitor monitor state number
4A fratm 1.0.0 1.0.0 enabled enabled appluprunning NMFR-4/DS1A
The application key should be specified only if you want to reconfigure the network module
to run a different type of application. Before changing the application, you must administer
the network module down as follows:
myswitch::configuration module> admin 4a down
Disabling the network module will destroy all
existing connections going through it.
Disable the network module [n]? y
Summary of Contents for forerunner series
