ForeRunner
ATM Switch Network Configuration Manual
A - 3
Confi
guring
SNMP
Configuring SNMP
A.2 SNMP Traps
SNMP traps are used to update the state of the network automatically to remote network
management hosts. The SNMP agent on the switch supports several SNMP traps.
The traps generated by the switch’s SNMP agent can be sent to as many destinations as
needed. These destinations are configurable via the ATM Management Interface (AMI). Each
destination must be an IP address of a network management host. The network management
host specified for a trap destination can be any host with which the switch has connectivity.
This means that the host does not have to be a directly connected ATM host. It can be on any
attached network. The following table describes the supported traps.
Table A.2 -
SNMP Traps Supported on the ForeRunner Switches
Trap
Number
Trap Name
Description
0
asxSwLinkDown
An asxSwLinkDown trap signifies that the sending
protocol entity recognizes a failure in one of the ATM
Switch links that is connected to another switch.
1
asxSwLinkUp
An asxSwLinkUp trap signifies that the sending proto-
col entity recognizes that one of the ATM Switch links
that is connected to another switch has come up.
2
asxHostLinkDown
An asxHostLinkDown trap signifies that the sending
protocol entity recognizes a failure in one of ATM
Switch links that is connected to a host.
3
asxHostLinkUp
An asxHostLinkUp trap signifies that the sending pro-
tocol entity recognizes that one of the ATM Switch
links that is connected to a host has come up.
4
asxNetModuleDown
An asxNetModuleDown trap signifies that the sending
protocol entity recognizes a failure in one of the ATM
Switch network modules, that is identified by the
board and the module numbers. This is probably
caused by a hot-swap of a network module.
5
asxNetModuleUp
An asxNetModuleUp trap signifies that the sending
protocol entity recognizes a new operational ATM
Switch network module, that is identified by the board
and the module numbers. This is probably caused by a
hot-swap of a network module.
Summary of Contents for forerunner series
