Place the two roof sections so that they sit on to the building with the overhang at the front.
Secure each roof section in place by screwing through the front and back panels of the building,
making sure that the screws locate into the battens of the roof sections using 2 x 50mm screws
for each side.
Line the catch up with the receiver making sure the screws will locate into the batten behind. Fix
using 2x20mm screws
Position the door end against the building and secure this in position as you did the back end,
using 3 x 60mm screws, evenly spaced, screwing through the door end into the side panels.
Lift the door and slot the hinges over the pins that are already fixed to the door end.
MUST PRE DRILL
MUST PRE DRILL
GTS01RFLH
GTS01DR
GTS01RFRH
GTS01DE
Warning:
Take care not to cut or trap
fingers when handling and
positioning the roof.
