—
55
—
Tent Camper Owner’s Manual
level galley”, lower the galley into the storage po-
sition by grabbing the handle and using an even
swing motion.
22. remove the faucet spout and store it back inside
the sink.
23. MaC, MaC off road, Classic and high Wall
models: if your tent camper is equipped with Flag-
staff’s E-Z Glide slide out dinette, detach the tent
material from the Velcro strips on both sides of the
slide out. Remove the cotter pins from the steel pins
extruding from the sidewall at the seal. Take hold
of the handle and push in the slide room. note:
make sure the path is clear inside the camper.
secure the slide room by turning and closing the
“lift and turn” latch to engage the lock.
Warning: When Closing up the Dinette
or CaMper in general, be sure to pull
out the tent fabriC anD Clear out of
the sliDe rail path before pushing in
the beD.
24. Close the entry door step into its stored position.
25. Release the Velcro strips securing the tent material
around the roof support poles.
26. Remove both lifter pole safety supports.
27. Detach the shock cord, tent flap Velcro and snap
under the bunk and lift the tent up onto the bunks.
28. Be sure the tent is pushed back and away from the
edge of the bunks.
29. ltD models only: Raise each bunk a few inches
with your legs and shoulder, and then remove the
bed support poles from the support sockets. Store
the support poles in a convenient location such as
under the bunk mattresses. Next, push both bunks
into their travel positions.
30. MaC, MaC off road, Classic and high Wall
models: push both bunks into their travel posi-
tions. Next remove the “double” pole bed supports
from the brackets. Store the support poles in a con-
venient location such as under the bunk mattresses.
note: be sure that the tent Does not
CatCh or binD When pushing in the
bunks.
31. Release the stabilizer jacks and raise them into their
storage position.
32. ltD and MaC models: insert the lifting mecha-
nism cranking lever into the winch adapter and
lower the roof by turning counter clockwise until
the roof stops. DO NOT OVER CRANK. The roof
can be fully retracted and still be 1 to 2 inches above
the side walls. Do not continue to turn the crank-
ing lever or damage to the lifter system will result.
33. For electric lift systems: to lower the roof, simply
push the lever on the power winch to the “down”
position. DO NOT OVER CRANK. The roof can
be fully retracted and still be 1 to 2 inches above
the side walls. Do not continue to push the lever or
damage to the lifter system will result.
note: When lowering the roof, make sure that the
tent is kept clear of the lifter posts when the roof
is lowered.
34. Store the awning when the roof is fully lowered.
35. Fasten the roof latches at each corner. It may be
necessary to push down slightly on the roof at each
corner to completely close the roof section and al-
low the latches to close.
36. Hitch the camper to your tow vehicle.
F
lagstaFF
F
olding
C
amper
- H
ard
s
ide
1. Once you have selected your campsite, make sure
you position your camping trailer on level ground.
Before starting the set up procedure, be sure that
the battery is properly connected to power the unit
if you plan on operating the optional power tongue
jack.
