WALL PANELS
Insert the Lintel (R) and knock into place. Ensure it
is flush to the top of the front panels.
Once all of the wall panels are up, begin to secure
each wall panel to the floor plate underneath. Use
3 x 35mm screws per panel externally.
55
55
57
57
53
53
54
54
Repeat the process from the inside, using 3 x
35mm screws per panel once again.
Where spline panels have been used to join side
panels, use 5 x 35mm screws to secure from top
to bottom along the connection. Do not screw
directly into the adjoining line. Repeat this process
for every adjoining panel.
Starting with the front panels, apply expanding
foam in the top groove, ready to add the wall
plates.
Use 35mm screws to secure the lintel in place by
screwing from both outside and inside of each
wall panel into the lintel. This will use a total of 8 x
35mm screws.
56
56
58
58
13
