00161-11/29/04
VERSO
OPERATING INSTRUCTIONS DESCRIPTION
16” OSCILLATING PEDESTAL FAN WITH REMOTE CONTROL
MODEL NO.: 13-07009
4. Fan blade assembly
• Put the fan blade (6) onto the electrical
axle centre (9) and insert completely
the blade fastening nut (5)
• Screw the screw into the electrical axle
centre in anti-clockwise direction and
then fix it.
5. Front guard assembly
• Put the hook of the front guard ring on
the top of rear guard.
• Put the rear guard into the front guard
ring to make them fit togheter comple-
tely.
• Tighten the fastening screw of the
lower of the front guard ring.
USING INSTRUCTIONS
Operating instructions
Strong
Middle
Weak
OFF switch
Press the oscillate control knob, the fan
begins to wave.
Pull the button, the fan stops waving.
You can choose the up and down angle and
control the wind direction freely
Height regulation
Loosen the fastening screw (16)
Regulate the electroplated pipe
To the needed height.
The operating instructions of the FS-35C, FS 40K
remote control standard fans.
SWING
STRONG
MIDDLE
WEAK
OFF
ON/Speed
OFF
TIMER
ON/Speed
Press the OFF key, all the wor-
king state will be cancel.
TIMER Press this key, you can
set the time needed. The follo-
wing diagram shows the order of
the time setting.
1 hour 2 hour 4 hour
Continue
Weak Middle Strong
Recycle
Press the key it will be in wind speed
state, the related indicator light will
be on. The following diagram shows
the order of the wind flow.
Press the oscillate control knob, the fan begins
to wave.
Pull the button, the fan stops waving.
The using instructions of the remote control
Open the cell cover, put in 2 AAA batteries and cover it
The remote control must face to the receiver
• The using range of the remote control must
be within 8 meters away from the receiver. If
the remote control isn’t faced to the receiver,
its using range will be narrowed.
• If this fan is used in the room with operating
high-power machines, the remote control will
be out of order.
• Don’t put any obstructions between the
receiver and the remote control
• Please take good care of the remote control
avoid knocking it.
• If you don’t use the remote control, please
take the cell out and keep it well.
Products characteristics
Quiet
Light and durable
Polish white colour
Maintenance and preservation
• Before tidying up the fan, it should be cleaned.
• This fan only needs general outside cleaning and maintenance.
Please wipe it with clean and soft cloth.
• Don’t wipe it with acid detergent, lamp oil, alcohol or chemical cloth in
case its colour be changed or go bad.
Simple breakdown clearing
Symptoms
Checking points
The fan blade doesn’t work when
the fan starts.
There’s unusual sound when the
fan starts.
The remote control is out of order.
If the cell is in short of supply. If
the cell is put in an opposite
direction.
Check if fan blade is assemble
properly.
Whether the plug is really put into
the outlet or not. Check fan blade.
cover
2 AAA batteries
