22
EN
Directions for use
Lighting and operation of the plancha
Before lighting your plancha, check that all
the conditions stated in the “PRECAUTIONS
FOR USE” section are met.
• Check that the control switch is on the « 0
» position as shown (Fig.1). Open the gas
supply (bottle for Butane/Propane, wall
valve for natural gas).
• Rotate the control switch
counterclockwise while holding it down.
(Fig 2)
• While still holdong the control swich down,
keep pressing on the ignition to generate
the sparks required for lighting of the
burners.
• Keep the control switch down for at least 5
seconds afer lighting the burner.
Control switch
Piezzo
Fig.1
Control switch
Piezzo
Fig.2
• Be sure to replace the container away
from any source of ignition.
• Do not plug the vents and regulary check
that every that they are clean to allow for
proper circulation of air to the burner.
• Do not modify the appliance, contact the
manufacturer or your retailer.
• Before using yout FORGE ADOUR plancha
after a period of storage and/or inactivity,
check is carefully in order to detect any
gas leak and/or clogging of the burners.
DO NOT CUT THE FOOD WITH A KNIFE
DIRECTLY ON THE COOKING PLATE.
Before each use, we recommend that you
preheat your plancha for at least 10 minutes;
with the switch on the high flame positions.
Precautions for use