Operator's Manual
3950 Series FD 3950PF
27
Setting the Rear
Edge Separator
Ł
Lower the rear edge separator (1).
Ł
Loosen the lock lever (2).
1
2
Ł
Displace the rear edge separator in such a way that the stop rods (3) touch
the rear edge of the paper stack.
3
4
5
The edges of the sucker cups (4)
should be placed approx. 3-4 mm
from the rear edge of the paper
stack.
For light paper stock it is re-
commended to place the
suckers even closer to the
rear edge of the stack.
This is achieved by moving
the stop rods (3) to the next
set of holes (5).
Ł
Tighten the separating head by turning the lock lever (2) clockwise.
Ł
Slide the left and right hold-down rods (6)
towards the outer edge of the paper stack
(approx. 1 cm inside the edge).
Ł
Adjusting the pressure of the hold-down
rods:
Heavy paper grades: Slide the weight (7) up.
Light paper grades: Slide the weight down.
6
7
Ł
Check whether the automatic height setting mechanism is switched on.
8
The automatic height setting mecha-
nism can be switched on and off by
pushing button (8). The illuminated
button shows that it is active.
For smaller paper sizes or flat sheets
the automatic height adjustment is
often not needed and can therefore
be switched off.
