Operator's Manual
3950 Series
Deliveries
40
Small Format
Vertical Stacker
SKM 36
The vertical stacker is mobile and height-adjustable by means of a gas-filled shock
absorber.
An additional control box (1) allows stopping and
starting the machine (2) and paper feed (3) to facili-
tate setting the hold-down rollers.
Setting the Transfer
Height
Ł
Loosen the handle (4) by turning it counter-
clockwise.
Ł
Lift or lower the delivery table.
Ł
Tighten the handle by turning it clockwise.
1
4
2
3
Setting the Format
Support rails (5) and guide rails (6) are clamped
to the cross rods by leaf springs.
They are easily removable and can be moved to
any position. Set for paper size as follows:
Ł
Set the left and right guide rail (6) to paper
width.
Ł
Move the support rails (5) accordingly.
Ł
Loosen the left and right clamp screws (9) and
set the hold-down rail (7) to the height of the folded paper, using the scale (8).
Retighten the clamp screws.
Use screws (10) for fine tuning the hold-downs.
5
6
6
7
8
9
1
If the sheets are not guided properly by the transport belts after the setting, adjust them
as follows:
Ł
Loosen the Allen screws of the belt
rollers (11).
Ł
Distribute the belt rollers across the
sheet width.
Ł
Retighten the Allen screws.
Ł
Set the idler rollers (12), belt tensioners
(13) and the lower belts (14) to paper size.
1
12
13
14
The upper and lower belts must run
on top of each other.
15
Ł
Position the back-up plate (15) in the
support rails.
The back-up plate must be adjusted
according to the folded stock size.
