19
1
Choose the Correct Dyna
mic
Crease Blade Set
This machine is supplied with a single standard crease blade set. Several optional blade
sets are available. Refer to the table below to see which type of blade set is most suitable
for your job.
Sheet Thickness
Blade Set
Crease Width
≥ 0.25 mm
(≥ 0.010”)
Standard (supplied with machine)
14200006
1.2 mm (0.051”)
≤ 0.25 mm
(≤ 0.010”)
Narrow (optional)
14200007
1.0 mm (0.039”)
≤ 0.15 mm
(≤ 0.010”)
Narrow (optional)
14200008
0.7 mm (0.028”)
The Standard blade set is designed to give a good crease on thick paper and thin card.
To do this, it makes a wide crease. A wide crease is necessary because it gives sufficient
material at the spine of the fold.
The Narrow blade set is designed to give a good crease on medium and thin paper. To do
this it makes a narrower crease than the Standard blade set does. A narrower crease is
necessary because if there is too much material at the spine of the fold, the fold might not
be accurate or square.
Always make sure you have the correct blade set installed before starting a job. When
running into creasing or folding problems, try a different blade set. This can help solve the
problem, even if it is not the usual blade set that is recommended.
Summary of Contents for Atlas C350
