82
3
Separation Pad Check
Rubber separation pads are used in the feeder to prevent several sheets from exiting the
feeder table area at the same time. Separation pad position is set at the factory. If frequent
misfeeds or double sheets occur the separation pad position may need to be adjusted by
the following procedure:
1.
Use a steel ruler or several stiff sheets of paper to check the gap between the separa
-
tion pads [B] and the lowest point of the vacuum belt roller is even and around 1 mm
(0.04”). If it is, the cause of misfeeds or double feeds is likely feeder parameters.
2. If not, use the included 2.5 mm hex key to loosen 2x bolts [A].
3. The separation pads [B] should now freely move up and down.
4.
Use a steel ruler or several stiff sheets of paper to set the gap between the separation
pads [B] and the vacuum belts to 1 mm (0.04”).
5. Tighten the bolts [A].
B
A
Summary of Contents for Atlas C350
