OPERATION
1.
Press power switch to the ON / “I” position. The power
switch is located under the lower fold table (Fig. 4a).
2.
Set the side guides for the width of the forms. Slide
each guide inward or outward to allow the forms to slide
freely.
(Fig. 4b)
3.
Select the type of fold desired by pressing the fold
selection icon (Fig. 5a). Note:
If the fold selection
icon shows the desired fold press the “Start/Stop” icon
to begin processing forms.
If the fold required is not available in the standard fold
settings, a custom fold set up is needed. See page 8.
4.
Select the standard fold type (Fig. 5b) needed and
press the “Enter” icon to set the fold stop
positions.
When the fold stops are set, the control panel will return
to the home screen. The selected fold icon will be
displayed.
6
Fig. 5a
Fold selection icon
1.
2.
3.
1.
2.
3.
Invoice
Flyer
Brochure
“Start/Stop” icon
Saved Jobs icon
Fig. 5b
Standard folds selection icons
Custom fold setup icon
Enter icon
Paper size selection icons
Fig. 4a
Fig. 4b
Side guides
