TO REPLACE SEALER ROLLERS
1. Turn power off and unplug power cord.
2. Remove side covers and upper fold plate.
3. Remove belts. (See belt replacement, pg 10.)
4. Remove top plates by unscrewing four screws.
5. Loosen or remove the five lower screws on each side.
6. Remove first roller by lifting up and out of machine.
7. Remove the two springs.
8. To remove second roller tilt stainless steel center away from roller.
9. Remove second roller the same way as the first roller.
10. To reassemble, repeat above steps in reverse.
11. Adjust belt tension. (See belt replacement, pg 10.)
1. Turn power off and unplug power cord.
2. Remove side covers and upper fold plate.
3. Remove control panel.
4. Remove belts. (See belt replacement, pg 10.)
5. Remove “C” and “E” rings on gears and sprocket.
6. Remove sprocket and chain.
7. Remove plastic gears.
TO REPLACE FOLDER (RUBBER) ROLLERS
9
Summary of Contents for FD 2052
Page 2: ...FD 2052 AutoSeal MAINTENANCE MANUAL FOURTH EDITION 12 2006...
Page 21: ...WIRING DIAGRAM 18...
Page 37: ......
Page 38: ......
