Formax FD 2052, Service Manual

5

1. To enter the manual batch counting mode press the 

“Batch Count” button and select “MANUBATCH” by 

pressing the “+” button (Fig 3a) .

2. Select the number of sheets to be folded by pressing 

the “+” or “-” buttons (Fig. 3b) , then press the “Start/

stop” button to start.

MANUBATCH:

The “Manubatch” or “manual batch” feature allows you to program the number of sheets you would like to 

process in a set.  When the set is complete the folder will stop and automatically reset the batch count to the 

previously set number of sheets, it will then fold the next set when the “Start/Stop” button is pressed.  

Fig. 3c

AUTOBATCH

TM

:

“Autobatch” or “automatic batch” allows you to batch count with automated features.  In the Autobatch mode 

you can program the number of sheets you would like to process in a set, the number of sets you would like 

and the delay between each set. For example: you can program 10 sheets to be pulled to create a set, then 

program 100 sets to be processed with a 3 second time delay between each set. 

1. To enter the Autobatch mode press the “Batch    

Count” button and select “AUTOBATCH” by pressing 

the “-” button (Fig 3a).

2.  Once you have entered the Autobatch mode press 

the “+” or “-” button and “Sheets”(Fig. 3c) will blink.  

Press the “+” or “-” buttons to increase or decrease the 

number of sheets to be pulled.

3.  When the sheet number is set wait 5 seconds and 

“Sets” (Fig. 3c) will blink.  Press the “+” or “-” buttons to 

increase or decrease the number of sets to be pulled.

4. When the number of sets has been selected wait 5 

seconds and “Delay” (Fig. 3c) will blink. Press the “+” 

or “-” buttons to increase or decrease the time delay 

between the sets.

5.When the settings are correct press the “Start/Stop” 

to start.

NOTE: 

The system will cycle through the settings until 

the “Start/Stop” button is pressed.

NOTE:

 If a fault occurs during a set the set will be 

completed when the fault is reset.

NOTE

: The batch counting program selected will 

remain on after the job is processed. You 

must

 press 

the Batch Counting button to turn off the light and 

cancel the batch count setting.

“Sheets” = Number of sheets of paper in a set

“Sets” = Number of sets to be processed

“Delay” = Time between each set

“C” = Total number of sheets processed

Batch Counting with chip rev. 4.08

Fig. 3a

Fig. 3b