Specifications
Cutting Style:
Cross Cut
Shred Size:
1/8” x 1 1/16”
Sheet Capacity:
Up to 20 sheets 20#, 1 CD, 1 Credit Card
Speed:
Up to 10 feet per minute
Feed Opening:
9”
Dimensions:
15.6” W x 10.6” D x 22.5” H
Bin Capacity:
6.6 gal.
Weight:
35 lbs.
Security Level:
Level 3
Power supply:
110V, 60Hz
Fig 1
Parts Identification
Control Identification
7
1
2
6
4
5
3
8
1. Paper Waste Bin
2. CD Infeed
3. Cutting Head
4. Paper / Credit Card Infeed
5. CD Waste Bin
6. Control Switch
7. LED Status Indicators
8. Base Cabinet
Set-up
1. Remove all parts from shipping box.
2. Remove paper waste bin and cutting head from base cabinet.
3. Carefully place the cutting head on the base cabinet.
NOTE
: The lugs on the
bottom of the cutting head latch into the openings on the base cabinet.
4. Push the paper waste bin into the base cabinet until it latches in the housing.
5. Plug in AC cable to appropriate outlet.
Operation
Press the rocker switch to “I”.
1. Switch will lock into place
2. Green LED lights up
3. Shredder is ready for operation (standby mode)
Switching the shredder on
Feed in only
one credit card
or
no more than 15 sheets
of paper into the top feed opening.
1. The light barrier detects paper or credit card and starts shredding automatically.
2. Three seconds after the feed opening is clear, the cutting blades stop and the shredder
automatically goes into standby mode.
Shredding paper and credit cards
The FD 8202 is equipped with a separate CD cutting unit. (Fig 1)
1. Push one CD into the feed opening on the front until the
cutting unit catches it.
2. The CD is cut into 5 strips.
3. Cutting blades will stop and shredder automatically goes
into standby mode.
Shredding CDs
I
On
O
Off
R
Reverse
LED Indicators
Possible Cause Solution
No LED lights up
Place the cutting head correctly on the base cabinet
and push the paper waste bin and CD waste bin in
fully.
Press “I’ on the switch
Both LEDs light up
Paper waste bin
is full
Empty the container. NOTE: If you remove the cutting
head from the base cabinet, be sure not to damage
the flap sensor on the bottom of the cutting head.
Red LED flashes
Overheated
The maximum uninterrupted operating time is
five minutes. Turn off and let the machine cool for
approximately 20 minutes.
Only the Red LED
lights up
Cutting unit
overloaded
Press R on the switch to reverse the cutting blades.
NOTE: The cutting unit starts in reverse with a delay of
2 seconds. Remove the paper. Do not feed more than
15 sheets of paper at a time.
Troubleshooting
Emptying the CD waste bin
The FD 8202 is equipped with a separate CD waste bin. (Fig 2)
1. Push down on the front of the bin (1)
2. Slide it toward the back of the shredder (2)
3. Lift the container out of the bracket (3)
4. Reverse these steps to re-install the waste bin
NOTE: The shredder will not operate without the CD waste
bin properly in place.
Fig 2
1
2
3
Green LED
Ready for operation
Red LED
Overloaded
Control Switch