Formax FD 8802 series, Instruction Manual

10

Exterior cleaning

•

 Turn shredder off and unplug from wall outlet.

•

 Wipe the exterior surfaces with a soft cloth. If the surfaces are very dirty, use a neutral detergent, then wipe 

again with a soft cloth.

CAUTION:

•

 Never put water directly on the surface of the shredder.

•

 Never clean the case with benzene or thinner, since it will cause discoloration.

Lubricating Shredder Mechanisms

• 

Cutting System:

The cutting system should be oiled once a month or as needed for optimal performance. 

1. Open the Cutting Block Access Door on the top of the shredder. Press latch and the handle    

    will spin around. Pull up on the handle.

2. Spray special cutting block oil through the paper inlet, onto the cutter rolls.

3. Close the Access Door and press the START button on the control panel.

4. Run the cutting system forward and backward several times, 

without feeding paper

. This will    

    help to remove paper shreds and particles.

A

• 

Drive Chains:

The drive chains should be checked during PMs,  

and greased as needed.

1. Switch off the shredder and unplug from wall  

    outlet. 

2. Remove both side covers.

3. Grease the cutting system conveyor belt   

    drive chain (A) and the motor cutting system  

    drive chain (B).

4. Replace side covers and plug in shredder.

B

• 

Synchronizing Wheels:

1. Switch off the shredder and unplug from wall  

    outlet. 

2. Remove left side cover.

3. Grease the synchronizing toothed wheel (C).

4. Replace side cover and plug in shredder.

C

Right Side

Left Side