Manual - Formech 450DT V1.0 - 0317
16
450DT Operating Using Saved Parameters
This operating screen will open. Two values will
show in the heater timer button.
The lower value shows the timer parameter for
the selected memory.
The top value shows the actual timer value.
When the heater is pulled forwards the timer will
count down.
When the timer reaches zero the timer buzzer will sound. The timer value will continue and show a negative
value to indicate that’s it has passed zero. All other buttons operate the same as previously described.
Heater power settings can be adjusted as previously described using the settings button.
When the SAVE button is pressed the actual heat time, including its negative count, will be carried over to
the settings screen for editing and saving as previously described.
Operating Procedure
450DT Saving Parameters to Memory
When save is pressed on the settings screen the
available memory slots are shown. Press the
forward arrow to advance to memory positions
11-20. Press the Back arrow to return to the
settings page if required. Press on a previously
saved memory slot to change an existing record
or select a new slot to save as required. When a
memory position is selected the following screen
will open.
Press on the memory title to edit the title using the
pop-up key pad as required. Press the save button
when complete.
Press the load button on the load options
screen to load previously saved parameters.
The load select screen will open. The previously
loaded memory slot will be remembered and
a will show next to the slot. Use the forward
arrow to scroll to memory slots 11-20 and select
the memory parameters as required. The program
memory operation screen will open. The following
section explains the operating differences.
450DT Loading Previously Saved Parameters from Memory
