Page 11
Optional extras
The following items can be purchased for your 508FS vacuum forming machine
1.
Service kit
2.
Reducing windows
3.
Blow mould window
4.
508DT
machine trolley
5.
508FS
cooling fan
1. It is unlikely that you will need to service or repair your machine for many years provided you follow the
maintenance information contained in this manual; however the table and clamp seals, which are
considered to be consumable items, will need to be replaced depending on the usage of the machine.
Therefore this kit contains the essential consumables (seals and pump filter) to ensure a good performance
of your machine year on year.
2. Formech has available 2 standard sizes of reducing plates for the 508, with apertures of 228 x 204mm
and 432 x 229 mm. Formech can also produce special size reducing windows. For more information please
contact our sales department.
3. You can use your vacuum forming machine to do blow moulding by fitting a special circular reducing
window to your machine. The maximum diameter you will get on the 508FS is 430mm. For more
information please contact our sales department.
Summary of Contents for 508DT
