Page 18
Operating procedures
BASIC OPERATION (Cont.)
25) Follow the instructions on the red screen.
The next screen will be displayed as soon as the heaters
are brought forward.
26) The timer starts automatically, counting up the time
previously set in the recipe, or it uses the default setting
if the machine has just been switched on.
27) At any time, you can push the heaters back to check
your material. The timer will then stop, and restart once
you bring the heaters forward again, providing the
heater is pushed fully back.
The ‘PRE-STRETCH’ feature can be used at this stage if
needed.
(508FS only)
Press ‘START VACUUM’ to go to the next screen.
The heaters need to be brought back and the table up at
this stage.
28) You can stop/start vacuum as required.
29) Once the material has cooled down, ‘RELEASE’ the
material from the mould.
30) ‘FINISH’ the process.
1-
You can either go back to the main menu
2-
or ‘SAVE TIMES JUST USED’ if the heating time
was shorter than your original settings.
Summary of Contents for 508DT
