28
5.10 Setting the pressure on back (pull-out) rollers
Using the cam (A), you may set the pressure on the back rollers. The back roller has 3
positions:
1.
Position (upper)
– in the upper position, there is a gap between the rollers of approx. 4
mm for handling the paper during installation.
Figure 14
2.
Middle position –
when the cam is in the middle position, the back upper roller rests
on the bottom roller only with its own weight. This position is suitable for the
operation of the laminator. Using your hand, you may turn the back roller in this
position and the cam is free on both sides.
Figure 15
3.
Position.
This is the bottom position of the cam when the rollers are pressed against
each other by springs. During ordinary operation in this mode, the foil is usually torn
inside the equipment due to too high tension of the back rollers.
Figure16
A
Summary of Contents for Foliant 370T
Page 2: ...2...
