-92- MBM-530NS User’s Manual
4.11 IDE HDD Auto Detection
Automatically detect and configure hard disk parameters. The Award BIOS
includes this ability in the event you are uncertain of your hard disk’s
parameters. To accept the optimal entries, press <Y> or else select from the
numbers displayed under the OPTIONS field; to skip to the next drive, press
<N>. If you accept the values, the parameters will appear list beside the drive
letter on the screen. The process then proceeds to the next drive letter.
Pressing <N> to skip rather than to accept a set of parameters causes the
program to enter zeros after that drive letter. When auto-detection is completed,
the program automatically enters all entries you accepted on the field for that
drive in the Standard CMOS Setup screen. Skipped entries are ignored and are
not entered in the screen. Please also see, “Standard CMOS Setup”.
If your hard disk was already formatted on an older previous system, incorrect
parameters may be detected. If the parameters listed differ from the ones
used when the disk was formatted, the disk will not be readable. If the
auto-detected parameters do not match the ones that should be used for your
disk, do not accept them. Press <N> to reject the presented settings and enter
the correct ones manually from the Standard CMOS Setup screen.
Summary of Contents for MBM-530NS
