14
1.1) Take off the oven bottom cover plate.
1.2) Loosen 4 screws to take off the side guard plate on the right of the bottom burner.
1.3) Remove the small plate from the bottom right corner on the back wall, you will see the pressure regulator
through the hole.
Injector direction for NG
Injector direction for LPG
1.4)Unscrew the cap with
injector from the regulator.
1.5)Unscrew the injector from the cap, do not
remove the spring from the injector. Reverse the
injector with spring and screw it back to the cap.
1.6)Screw the cap with
injector back to the regulator.
1.7)Assemble the small plate and burner side guard plate back to place, and put back the oven bottom cover.
STEP 2
: Surface Burners
2.1)Remove cooking grates and burner caps.
2.2)Lift off burner spreader.
2.3)Remove the factory installed natural gas injector from the nozzle holders
by using a 7mm socket wrench.
2.4)Replace the LP injector in each nozzle holder. Tighten each injector
properly.
Do not to over tighten the injector.
2.5)Place the burner spreader and caps back to correct position. Put back
the cooking grates.
CAUTION
Handle carefully when removing and replacing gas components. Use proper
support to prevent damage to components.
IMPORTANT:
Each injector has a number indicating its flow diameter, the number is printed on the body. Consult
the table below for matching nozzles with surface burners.
Socket
