•
This appliance must be installed and the gas cylinder stored in accordance with LPG
storage regulations.
•
Do not obstruct the ventilation holes of the cylinder housing
•
Do not move the heater when in operation.
•
Switch off the gas regulator before moving the heater
•
The rubber hose should be inspected and changed on a yearly basis.
•
This heater is designed to be used with 11 kg or 13kg patio/leisure propane gas cylinders
READ THE INSTRUCTIONS BEFORE USING THIS APPLIANCE. THE APPLIANCE MUST BE
INSTALLED IN ACCORDANCE WITH THE INSTRUCTIONS.
•
Do not use this patio heater indoors, as it may cause personal injury or property damage.
•
This outdoor heater is not intended to be installed on recreational vehicles and/or boats.
Installation and repair should be done by a qualif ied service person.
•
Improper installation, adjustment, alteration can cause personal injury or property damage.
•
Do not attempt to alter the unit in any manner.
•
Never replace or substitute the regulator with any regulator other than the factory
suggested replacement.
•
Do not store or use gasoline or other flammable vapors or liquids in the heater unit.
•
The whole gas system, hose, regulator, pilot or burner should be inspected for leaks or
damage before use, and at least annually by a qualif ied service person.
•
All leak tests should be done with a soap solution. Never use an open flame to check for
leaks. Do not use the heater until all connections have been leak tested.
•
Turn off the gas valve immediately if smell of gas is detected. Turn Cylinder Valve OFF. If
leak is at Hose/ Regulator connection: tighten connection and perform another leak test.
If bubbles continue appearing should be returned to hose’s place of purchase. If leak is
at Regulator/Cylinder Valve connection: disconnect, reconnect, and perform another leak
check. If you continue to see bubbles after several attempts, cylinder valve is defective and
should be returned to cylinder’s place of purchase.
•
Do not transport heater while it’s operating.
•
Do not move the heater after it has been turned off until the temperature has cooled
down. Keep the ventilation opening of the cylinder enclosure f ree and clear of debris.
•
Do not paint the radiant screen, control panel or top canopy reflector.
•
Control compartment, burner and circulation air passageways of the heater must be kept
clean. Frequent cleaning may be required as necessary.
IMPORTANT SAFETY MEASURES
5
FØRO PH13000 - MANUAL
EN
