LaserPro Equipment for Arena Laser Tag
User Manual
47
Do not take battery to minimal charge. Often recharging is more preferable - it does not
harm the battery.
Batteries charging.
Use ventilated and fireproof room to charge the batteries. In case of possible
inflammation of batteries, they shall not cause fire in the entire premise.
Burning Li-on batteries are impossible to water-quench (hydrogen is formed) and carbon
dioxide extinguishers (lithium enters into reaction with carbon dioxide). Dry sand, cooking salt,
baking soda are possible to apply as well as to cover the burning battery by thick heat-resistant
fabric. Thus, it is recommended to keep sand nearby the place of battering charging.
Never try to charge non-chargeable Li-on batteries! Attempt to charge these devices may
cause explosion and inflammation, which spread toxic agents.
In case of battery damage do not recharge it!
Use only those charging devices intended for this type of the batteries.
Temperature mode
of Li-ion batteries charge affects their capacity being reduced during
charging process in the cold or heat. The charge may be performed under the environmental
temperature in the range of +4°С to + 40°С, however, optimum charging temperature is +24°С.
Before using charging device check connection accuracy and quality of all leads. In case of
some charging device leads damage they shall be replaced prior to devise utilization.
Fix equipment on the flat, firm, non-combustible surface when charging. Remove highly
inflammable objects located nearby.
If charging equipment having in-built battery one must observe the electrical safety
precautions.
It is not advisable to keep charging device in the mains socket, if it is not used at the
moment as intended.
When powering device off, pull it out of the socket holding the plug and not the electric
cord.
Do not ever leave equipment unattended in the charging process!
If when charging the
battery peculiar scent, heat, smoke evolve indicating a case deformation, one should
disconnect the charging device from the mains, and battery - from charging device.
Charging cycle
of fully charged batteries of blaster&vest kit is 5-6 hours. Full charge
reaches when voltage comes to peak value, and charging rate decreases up to 0.1 … 0.07 A
depending on battery model.
If compartment swells during charging, do not ever pin elements, especially if it is still hot.
It should be placed to salt water and wait until this element cools down. Upon cooling carefully
pin the outer shell and then put the compartment back to salt water. After that procedure
battery is subject to utilization.
In a
contingency case
lithium compartments may get out of order being short circuit inside.
Thus,
the element itself may look unimpaired in outward appearance. In any case the batter should
be better taken and observed attentively in the course of 20 minutes.
In case of battery depressurization and
electrolyte contact with skin
of hands or eyes,
rinse immediately affected place by running water within 15 minutes and see a doctor.
Otherwise, it may cause chemical burn, partial or full loss of sight.
Batteries storage and their utilization
