MICROpod User Manual
A0016-09-0001
Version Number: 4.00
Page v
Template Version: 2.01
Revision Date: 24.06.2013
Forsberg Services Limited
Company Registration No: SC104949
Registered Office: Forsberg Services Ltd, 1 East Craibstone Street, Aberdeen, AB11 6YQ
1
Notices
The following notices apply to the MICROpod.
For more information on emissions testing, please refer to the regulatory body in your geographic area. For example, in
Europe that is the Conformité Européenne (CE) and in the US the Federal Communications Commission (FCC).
1.1
CE Notice
The MICROpod enclosures carry the CE mark.
The MICROpod meets the performance requirements of specification EN 301 489-1: V1.6.1 (2005-09)
1.2
FCC Notice
The equipment described in this manual has been tested pursuant to Part 15 of the FCC Rules and
found to comply with the limits for a Class A digital device for use in commercial business, and industrial
environments. Operation is subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation. These limits are designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. The equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio
and television reception. Operation of this equipment in a residential area is likely to cause harmful interference in which
case the user will be required to correct the interference at own expense.
If this equipment does cause interference to radio or television reception, which can be determined by turning the
equipment off and on, you can try to correct the interference by one or more of the following measures:
• Reorient the receiving antenna.
• Relocate the receiver relative to the equipment which it interferes.
• Power the equipment from a different AC receptacle so that this equipment and the interfered equipment are
on different branch circuits. If necessary, contact Forsberg Services Ltd. for additional advice.
WARNING!
Changes or modifications to this equipment not expressly approved by Forsberg Services Ltd could result in a violation of
Part 15 of the FCC rules and void the user’s authority to operate this equipment.
1.3
IPX7 Notice
The MICROpod unit is waterproof in accordance with IEC 60529 IPX7. IEC 60529 is a European system of test specification
standards for classifying the degrees of protection provided by the enclosures of electrical equipment. An IPX7 designation
means the MICROpod case can withstand accidental immersion in one meter of water for up to 30 minutes.
IMPORTANT!
An antenna or suitable waterproof dust cap must be attached to the TNC connector to obtain full IPX7
1.4
RoHS Notice
The MICROpod is compliant with the European Union (EU) Restriction of Hazardous Substances (RoHS) Directive
2002/95/EC.
