6. While your PC remains connected, cycle power on the Integrity system frame and
wait patiently for the system to reset and reload all settings. This will take several
minutes and varies depending on how many service cards are installed in the rear
of the frame. While the reload is progressing, a series of status messages will
appear in the HyperTerminal window which can be ignored. The reload is
complete when you see the following prompts in the HyperTerminal dialogue
window:
Starting Heart
[DONE]
Pulse:
60
BPM
You may now retrieve the new settings by typing the following:
ifinfo [ENTER]
7. Close the HyperTerminal window and disconnect the serial crossover cable from
the DB9 connector on the ZFCB. Make sure the ZFCB card is still seated
securely in its card socket and that the card locks are fully engaged after removing
the serial cable. Replace the EMI shield cover using the nine Phillips head
countersink screws, oriented so that the LED status array is visible through the
cover when secured. Verify that the frame power supplies are switched on and
replace the snap-on front cover. The RCP-303 Express remote control panels will
recognize the new frame settings automatically.
If you have questions, comments, or suggestions, please contact us directly at Fortel
DTV.
Steve Addison
770-806-0234 ext. 222
James Griffin
770-806-0234 ext. 111
james.griffin@forteldtv.com
Fortel DTV Inc.
3305 Breckinridge Blvd., Suite 118
Duluth, GA 30096-6885 USA
+1 (770) 806-0234 Main
+1 (770) 806-0244 Fax
Integrity FRM-501 Compact System Frame User Manual
14
