Rack mounting
Position the FRM-501 frame in your equipment rack and secure the attached L-brackets
to the front rack rails using four of the black finish 10-32 x 1” screws from the enclosed
hardware kit.
The rear of the frame may also be secured using the rear mounting kit.
Attach the two short brackets first, one on each side of the frame, using two of the brass
finish 10-32 x 1/2”screws for each side.
Temporarily affix one extension rail to the rear equipment rack rails. Mark the extension
rail hole which lines up with the slot in the short bracket. Remove the extension bracket
from the rack and attach a clip nut at the marked position on the extension. Reinstall the
extension rail, attaching it to the rear equipment rack rail using a single black finish 10-32
x 1” screw, then securing the extension to the short bracket using the brass finish 10-32 x
½” screw by installing it through the slot and into the clip nut as shown below. Repeat
this for the other side.
Integrity FRM-501 Compact System Frame User Manual
7