Refer all servicing to qualified service personnel. Servicing is required when the apparatus has
been damaged in any way, such as power-supply cord or plug is damaged, does not operate
normally, or has been dropped.
“Changes or modifications not expressly approved by the manufacturer could void the user’s
authority to operate the equipment”.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules.
Radar Safety and Transmit Exposure
The Fortem TrueView radar is an electronic device that produces radio frequency (RF) emissions
to perform RAdio Detection And Ranging (RADAR). Care should be taken to ensure two safety
factors:
1. Personnel safety: Ensure the radar is pointing in a safe direction where people in close
proximity (within 3 ft) are not directly exposed to the RF energy for sustained periods of
time (>30 min).
2. Equipment safety: Ensure that the radar is not too close (within 6 ft) to other materials
that produce strong RF reflections back into the receive (RX) antenna, particularly during
indoor testing. This includes sheet metal, steel reinforced walls, corner reflectors etc.
A transmitting radar can also get warm to the touch. For this reason, evaluation units are
shipped with an evaluation stand that provides a small amount of airflow to reduce the exterior
temperature of the unit in indoor or static testing scenarios. Suggested best practice is to use
the TrueView user interface to turn off transmit when not actively testing radar detection.
Note, TrueView radar is designed to operate between -20ºC to 50ºC (-4º F to 122ºF) ambient
temperature.
Please do not hesitate to contact customer support if you have any questions regarding setup
or operation of your TrueView Radar.
Email:
support@fortemtech.com
Phone:
+1 (385) 375-3233
2
