CHOICE 3 -
This method must be programmed by the installer during installation. This method
will activate the remote car starter sequence:
ACTIVATION :
STEP 1
The vehicle must be running.
STEP 2
Make sure that all doors are closed and that the transmission is in
the NEUTRAL position.
STEP 3
Press the brake pedal.
STEP 4
Engage the parking brake.
STEP 5
Release the brake pedal.
STEP 6
Remove the key from the ignition barrel : the vehicle will remain
running with the Remote-Starter.
STEP 7
Exit the vehicle and close all of the doors.
The Remote-Starter will stop running once all the doors
are closed.
STEP 8
The vehicle is now ready to be remote started.
If the parking brake is disengaged, the hood is opened, or any of the doors are opened, Ready
Mode will deactivate to cancel. Start over the sequence from step 1.
Page 11 / 23
Summary of Contents for 12084A-DL1004
Page 2: ...TABLE OF CONTENTS ...