READY MODE (MANUAL TRANSMISSION ONLY)
Four activation methods are possible, please consult the salesman or installer to determine which
of these modes applies to your vehicle. There are always safety concerns for a manual transmis-
sion vehicle to accidentally start while in gear, Ready Mode alleviates these concerns. The driver
must enable Ready Mode in order to Remote-Start the vehicle at a later time. Once Ready Mode
is set-up the vehicle can be started/stopped at will, as many times as needed. However once the
parking brake is disengaged, the hood is opened, or any of the doors are opened, Ready Mode will
deactivate and the vehicle will not start until Ready Mode is reactivated.
BY DEFAULT -
This method will activate the remote car starter sequence ::
ACTIVATION :
STEP 1
The vehicle must be running.
STEP 2
Make sure that all doors are closed and the transmission is in the
NEUTRAL position.
STEP 3
Press the brake pedal.
STEP 4
Engage the parking brake.
STEP 5
Release the brake pedal.
STEP 6
Press the START button for 3 seconds.
The parking lights will flash once and then remain on.
STEP 7
Remove the key from the ignition barrel : the vehicle will remain
running with the Remote-Starter.
STEP 8
Exit the vehicle and close all of the doors. The Remote-Starter will
stop running once all the doors are closed.
STEP 9
The vehicle is now ready to be remote started.
Page 9 / 23
Summary of Contents for 12084A-DL1004
Page 2: ...TABLE OF CONTENTS ...